标准光模块
100G CFP SR10光模块（400m）
Description
100G CFP SR10光模块（400m）
北亿纤通（F-tone Networks）100G CFP SR10光模块（400m）专为100G以太网100GBASE-SR10设计,可连接多个850nm多模光纤.
特征:
• 可热插拔的CFP封装
• 符合CFP MSA标准
• 符合IEEE 802.3ba 100GBASE-SR10标准
• 10通道全双工收发模块
• 支持100Gb / s的聚合比特率
• 10通道850nm VCSEL阵列
• 10通道PIN光电探测器阵列
• 最大功耗8W
• OM3 MMF的最大链路长度为300米,OM4 MMF的最大链路长度为400米
• 单MTP / MPO插座
• Tx输入和Rx输出CDR重定时
• 工作温度范围:0至70°C
• 单3.3V电源
• 符合RoHS-6（无铅）
应用:
• IEEE 802.3ba 100GBASE-SR10
Performance figures, data and any illustrative materialprovided in this data sheet are typical and must bespecifically confirmed in writing by F-tone beforethey become applicable to any particular order or
contract. In accordance with the F-tone policy ofcontinuous improvement specifications may change
without notice.
The publication of information in thisdata sheet does not imply freedom from patent or otherprotective rights of F-tone or others. Further detailsare available from any F-tone sales representative.
Related Products
CFP-40G-SR4
- Transmission data rate up to 11.2Gbit/s per channel
- CFP MSA compliant
- Compliant to IEEE 802.3ba specification for 40GBASE-SR4 links
- Up to 11.2 Gbps per channel bandwidth,
- OTU3 compatible
- 4 channels 850nm VCSEL array
- 4 channels PIN photo detector array
- OM3 Multimode Fiber cable of up to 300m and OM4 Multimode Fiber cable of up to 400m
- MDIO digital diagnostic and control capabilities.
- compliant to CFP MSA Management Interface Specification, Draft 1.4
- TX input and RX output CDR retiming
- Hot pluggable electrical interface
- Power class 1 (<8W max)
- Operating case temperature 0°C to +70°C
- 3.3V power supply
- RoHS 6 compliant（lead free）
100G CFP to QSFP28 Adapter
100G CFP to QSFP28 Adapter：北亿纤通100G CFP to 100G QSFP28 Adapter转接器实现CFP接口（10X10Gbps）与QSFP28接口（4X25Gbps）双向转换，满足IEEE 802.3ba 100GBASE-LR4和IEEE 802.3bm 100GBASE-SR4协议，最大功耗低于4W，支持前向纠错编码（FEC）、数字诊断（DDM）功能。为100G以太网和电信网提供高性能、热插拔互联方案。 经验证，采用100m OM4多模光纤进行传输，该模块实测功耗低于2.3W，并成功实现4小时连续工作零误码。
CFP4-100G-SR4
CFP4-100G-SR4：F-tone Networks’s 100Gb/s transceiver module for optical communication applications compliant to 100GBASE-SR4 of the IEEE P802.3bm standard. The module converts 4 input channels of 25Gb/s electrical data to 4 channels of VCSEL optical signals over 4 multimode fibers for 100Gb/s optical transmission. Reversely, on the receiver side, the module receives 4 channels of VCSEL optical signals over 4 multimode fibers and then converts them to 4 output channels of electrical data.The high speed VCSEL transmitters and high sensitivity PIN receivers provide superior performance for 100Gigabit Ethernet applications up to 100m links over OM4 multimode fibers and compliant to optical interface with IEEE802.3bm Clause 95 100GBASE-SR4 requirements.
100G LR4 OTU4 CFP2光模块
100G LR4 OTU4 CFP2光模块:兼容CFP2 MSA,符合OTU4,传输距离可达10km,4并联电串行接口和CML信号交流耦合,MDIO实时诊断和控制能力,TX和RX CDR再定时输出输入,工作温度0°C + 70°C,3.3V电源。北亿纤通专业研发生产100G LR4 OTU4 CFP2光模块,工业级100G LR4 OTU4 CFP2光模块,100G LR4 OTU4 CFP2,工业级100G LR4 OTU4 CFP2,是一个专业的100G LR4 OTU4 CFP2光模块厂家,有很好的100G LR4 OTU4 CFP2光模块价格
100G CFP LR4 Optical Transceiver
100G CFP LR4 Optical Transceiver：100G CFP LR4光模块支持100GbE和OTU4数据在10km单模光纤上的传输,采用4个EML激光器和PIN接收器组成和波分复用技术将4路不同波长复用在一根光纤上传送，该光模块符合 CFP MSA和IEEE 802.3ba* 100GBASE-LR4。可通过MDIO进行数字监控功能。
功能特性
· 符合CFP MSA 标准
· 支持工作速率103.1Gb/s aggregate bit
· 兼容 OTU4
· 发射端采用4x 25Gb/s LAN-WDM transmitter
· 在单模光缆可传输10km
· 工作温度：商业级0℃～+70℃/工业级-40℃～+85℃ 可选
· 电气接口采用 CAUI electrical interface
· 支持MDIO接口
· 光接口采用双工LC或SC接口
· 采用3.3V电压
100G CFP2转QSFP28适配器
100G CFP2转QSFP28适配器
北亿纤通（F-tone Networks）100G CFP2转QSFP28适配器设计用于将CFP2接口转换为QSFP28端口.