标准光模块
10Gbps SFP+ 850nm 300m 光收发一体模块
Description
10Gbps SFP+ 850nm 300m 光收发一体模块
产品描述
该850 nm VCSEL 10Gigabit SFP+光模块设计用于通过50/125μm或62.5/125μm多模光纤传输和接收光学数据。SFP+SR模块的电气接口符合SFI电气规范。发射器输入和接收器输出阻抗差为100欧姆。数据线内部交流耦合。该模块提供差分端接，并减少差分到共模的转换，以实现高质量的信号端接和低EMI。SFI通常操作超过200mm的改进的FR4材料，或者使用一个连接器操作高达约150mmof的标准FR4。
发射机将10Gbit/s串行PECL或CML电气数据转换为符合10GBASE-SR标准的串行光学数据。提供了开放集电极兼容的传输禁用（Tx_Dis）。该引脚上的逻辑“1”或无连接将禁止激光器传输。此引脚上的逻辑“0”提供正常操作。变送器具有内部自动功率控制回路（APC），以确保在电源电压和温度变化期间输出恒定的光功率。提供了一个与集电极开路兼容的传输故障（TFault）。TX_Fault（TX_Fault）是一个模块输出触点，当该触点为高电平时，表示模块变送器已检测到与激光器操作或安全相关的故障状况。TX_Fault输出触点为开路漏极/集电极，应使用4.7-10 kΩ范围内的电阻器将其拉至主机中的Vcc_Host。TX_Disable是一个模块输入触点。当TX_Disable被断言为高电平或保持打开时，SFP+模块变送器输出应关闭。该触点应通过4.7 kΩ至10 kΩ的电阻器拉高至VccT
接收器将10Gbit/s的串行光数据转换为串行PECL/CML电数据。提供了集电极开路兼容的信号损耗。Rx_LOS当为高时表示光信号电平低于相关标准中规定的电平。Rx_LOS触点为开路漏极/集电极输出，应使用4.7-10 kΩ范围内的电阻器或有源终端将其拉至主机中的Vcc_Host。建议对发射机和接收机进行电源滤波。Rx_LOS信号旨在向安装SFP+的系统提供接收信号强度低于指定范围的初步指示。这种指示通常指向未安装的电缆、断裂的电缆，或电缆远端的禁用、故障或断电变送器。
产品特征
● 符合IEEE 802.3ae 10GBASE-SR的光学接口
● 电气接口符合SFF-8431
● 可热插拔
● 支持高达10.3 Gb/s的速率
● 1G/2G/4G/8G/10G光纤通道应用。
● 850nm VCSEL发射器，PIN光电探测器
● 2000MHz/km MMF上最大链路长度为300m
● 低功耗
● 全金属外壳提供卓越的EMI性能
● 高级固件允许将客户系统加密信息存储在光模块中
● 经济高效的SFP+解决方案，实现更高的端口密度和更大的带宽
● 对于OBSAI应用，速率分别为6.144Gb/s、3.072 Gb/s、1.536 Gb/s和0.768 Gb/s。
● 对于CPRI应用程序，速率分别为6.144Gb/s、3.072 Gb/s、2.4576 Gb/s、1.2288 Gb/s和0.6144 Gb/s。
● 符合RoHS6标准（无铅）
● 工作情况温度：
商业级：0~+70℃
工业级：-40~+85℃
应用范围
● 10.3125Gbps的10GBASE-SR
● 10GBASE-SW，9.953Gbps
● 其他光链路
● 对于OBSAI应用，速率分别为6.144Gb/s、3.072 Gb/s、1.536 Gb/s和0.768 Gb/s。
● 对于CPRI应用程序，速率分别为6.144Gb/s、3.072 Gb/s、2.4576 Gb/s、1.2288 Gb/s和0.6144 Gb/s。
机械尺寸
订购信息
|
产品型号 |
产品描述 |
|
FTCS-851X-02D |
850nm, 10Gbps, SFP+ 300m, 0ºC ~ +70ºC（商业级） |
|
FTCS-851X-02DI |
850nm, 10Gbps, SFP+ 300m, -40 to +85℃ （工业级） |
注：本产品有全国产化型号可选
本产品为SFP+系列光模块，如有需要，请您联系我们:+86-028-85255257。
Important Notice
Performance figures, data and any illustrative material provided in this data sheet are typical and must be specifically confirmed in writing by F-tone Networks before they become applicable to any particular order or contract. In accordance with the F-tone Networks policy of continuous improvement specifications may change without notice.
The publication of information in this data sheet does not imply freedom from patent or other protective rights of F-tone Networks or others. Further details are available from any F-tone Networks sales representative.
Related Products
10Gbps 2km SFP+ Optical Transceiver
10Gbps 2km SFP+ Optical Transceiver
Product description
This 1310 nm FP 10Gigabit SFP+ transceiver is designed to transmit and receive optical data over single mode optical fiber for link length 2km.The SFP+ 2km module electrical interface is compliant to SFI electrical specifications. The transmitter input and receiver output impedance is 100 Ohms differential.
10Gb/s SFP+ 1310nm 10km Optical Transceiver Module
10Gb/s SFP+ 1310nm 10km Optical Transceiver Module
Description
F-tone Networks’FTCS-131X-10Dxx SFP+ transceiver is designed for use in 10-Gigabit Ethernet links up to 10km over single mode fiber. The module consists of 1310 DFB Laser, PIN and Preamplifier in a high-integrated optical sub-assembly. Digital diagnostics functions are available via a 2-wire serial interface, as specified in SFF-8472.
10Gbps 20km SFP+ Optical Transceiver
10Gbps 20km SFP+ Optical Transceiver
Product description
This 1310 nm DFB 10Gbps SFP+ transceiver is designed to transmit and receive optical data over single mode optical fiber for link length 20km.The SFP+ 20km module electrical interface is compliant to SFI electrical specifications. The transmitter input and receiver output impedance is 100 Ohms differential.
10Gb/s SFP+ 1550nm 80km Optical Transceiver Module
10Gb/s SFP+ 1550nm 80km Optical Transceiver Module
Description
FTCS-151X-80Dxx SFP+ transceiver is designed for use in 10-Gigabit Ethernet links up to 80km over single mode fiber. The module consists of 1550 EML Laser, APD and Preamplifier in a high-integrated optical sub-assembly. Digital diagnostics functions are available via a 2-wire serial interface, as specified in SFF-8472.
10Gb/s SFP+ 1550nm 120km Optical Transceiver Module
10Gb/s SFP+ 1550nm 120km Optical Transceiver Module
Description
F-tone Networks’FTCS-151X-H2Dxx SFP+ transceiver is designed for use in 10-Gigabit Ethernet links up to 120km over single mode fiber. The module consists of 1550 EML Laser, APD and Preamplifier in a high-integrated optical sub-assembly. Digital diagnostics functions are available via a 2-wire serial interface, as specified in SFF-8472.
10Gb/s Copper SFP 光收发一体模块
10Gb/s Copper SFP 光收发一体模块
产品描述
FTCS-10G-Txx铜质小型可插拔（SFP）收发器基于SFP多源协议（MSA）。它们与IEEE STD 802.3an中规定的千兆以太网标准兼容。10GBASE-T物理层IC（PHY）可以通过I2C访问，允许访问所有PHY设置和功能。