标准光模块
工业级6G CPRI SFP+光模块
Description
工业级6G CPRI SFP+光模块
北亿纤通（F-tone Networks）的工业级6G CPRI SFP+移动基站光收发模块（GPP-xx6G-xxT）用于6Gbps CPRI/OBSAI移动前传链路,同时兼容4.9Gbps CPRI,通过光纤传输距离最高可达300米至80千米。
特征:
▪ 采用可热插拔的SFP+封装
▪ 全双工收发一体模块
▪ VCSEL/FP/DFB/EML激光器和PIN/APD光电探测器
▪ 符合SFP+ MSA和CPRI/OBSAI标准
▪ 最大速率高达6Gbps
▪ 可选波长：850nm、1310nm和1550nm
▪ 通过光纤传输距离最高可达300米至80千米
▪ 最大功耗小于2W
▪ 双工LC光口
▪ 工作温度范围从-40到+85摄氏度
▪ 电源电压3.3V
▪ 符合RoHS环保标准（无铅）
应用:
▪ 6G CPRI/OBSAI移动前传网络
▪ 4.9G CPRI移动前传网络
Performance figures, data and any illustrative materialprovided in this data sheet are typical and must bespecifically confirmed in writing by F-tone beforethey become applicable to any particular order or contract. In accordance with the F-tone policy ofcontinuous improvement specifications may change without notice.
The publication of information in thisdata sheet does not imply freedom from patent or otherprotective rights of F-tone or others. Further detailsare available from any F-tone sales representative.
Related Products
Tunable DWDM SFP+ Transceiver
F-tone tunable SFP+ transceiver is fully compliant to SFP+ MSA. It supports 50GHz DWDM 10Gb/s SONET/SDH, 10 Gigabit Ethernet, and 10 Gigabit Fibre Channel applications over fiber without dispersion compensation. Digital diagnostics functions are available via a 2-wire serial interface, as specified in the SFP+ MSA and SFF 8472 MSA.
SDH SONET SFP+ transceiver
Compliant with Small Form Pluggable (SFP) Multi Source Agreement (MSA) mechanical and electrical specifications for LC Duplex transceivers, ANSI Fibre Channel transceiver for FC-PI-5 and FC-PI-2 gigabit applications.
CWDM 10G SFP+ Transceiver
F-tone CWDM SFP+ transceiver is small form factor pluggable module for bi-directional serial optical data communications such as IEEE 802.3ae 10GBASE-LR/LW/ER/ZR. It is with the SFP 20-pin connector to allow hot plug capability. Digital diagnostic functions are available via an I2C. This module is designed for single mode fiber and operates at a nominal wavelength of CWDM wavelength.
BIDI SFP+ transceiver
F-tone BIDI SFP+ transceivers are designed for bi-directional 10G serial optical data communications such as IEEE 802.3ae 10GBASE-BX by using 1330(1270nm) transmitter and 1270(1330) nm receiver. The transceiver consists of two sections: The transmitter section uses a multiple quantum well 1330(1270) nm DFB laser and is a class 1 laser compliant according to International Safety Standard IEC 60825. The receiver section uses an integrated 1270(1330) nm detector preamplifier (IDP) mounted in an optical header and a limiting post-amplifier IC.
10G SFP+ Transceiver
F-tone SFP+ transceiver are multi-purpose optical modules for 10Gbit/s data transmission applications at 850nm, 1310nm and 1550nm. The transceivers are ideally suited for datacom and storage area network (SAN/NAS) applications based on the IEEE 802.3ae and Fibre Channel standards, Fiber Channel 10G, 8.5G, 4.25G, 2.125G, 1.0625G, 10G BASE-SW/SR/LR/ER, 1000 Base-SX Ethernet.
工业级10G CPRI BiDi SFP+光模块
工业级10G CPRI BiDi SFP+单纤双向光模块
北亿纤通（F-tone Networks）的工业级10G CPRI BiDi SFP+单纤双向移动基站光收发模块用于数据中心万兆以太网和CPRI移动前传链路,通过单根单模光纤（SMF）传输距离最高可达10千米、20千米、40千米或60千米。